Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Keller Owner’s Guide

Ghost Controls keypad and intercom repair in Keller typically runs $185 to $410 installed, and we stock the common replacement parts on the truck so most jobs are finished in one visit. If your keypad has gone dark, stopped accepting the code, or the intercom crackles and drops calls, you’re usually looking at a failed circuit board, corroded contacts, or a worn keypad membrane, not a full system replacement. We’re an independent service provider, not affiliated with Ghost Controls, but we’ve been repairing their openers across Keller long enough to know which parts fail first and which ones are worth replacing.

Call (254) 330-8718

Which Ghost Controls Models This Applies To

Ghost Controls sells its keypads and intercoms under a few different model lines, and the repair approach changes depending on which one you have. The most common units we see in Keller driveways are the AX2, AXP1, and HDP1 wireless keypads, and the WKP1 wired keypad. The HDP1 is the heavy-duty weatherproof version, and in Texas heat, that extra sealing matters more than most homeowners expect. If you’re not sure which model you have, look inside the battery compartment or on the back of the unit for a small white label with the model number printed on it. Take a photo of that label before you call us. It saves us a trip back to the truck.

On parts, we lean OEM Ghost Controls when the failure is electrical, because aftermarket boards for these units have a spotty track record with signal consistency. For simple mechanical pieces like the keypad housing or the rain shield, a quality aftermarket part is often indistinguishable and costs less. The honest answer is that Ghost Controls parts are not overly expensive compared to the opener itself, so when the difference is $20 or $30, we’d rather install the real thing and not have to come back under our 90-Day Done Right Promise.

Signs Your Ghost Controls Keypad & Intercom Repair Is Failing

• Keypad stays dark or lights up erratically. This is almost always a battery contact issue or a failing internal voltage regulator. If fresh batteries don’t bring it back to life within a few seconds, the board itself is likely done.
• Code works sometimes, not others. Intermittent operation is the classic sign of a cracked solder joint on the keypad’s transmitter board. Thermal expansion from Texas heat cycles makes the crack open and close, which is why it works in the morning and quits by 3 p.m.
• Intercom buzzes or drops calls. A steady hum usually points to a failing capacitor in the intercom’s power supply. Dropped calls are more often a corroded connection at the junction box where the intercom wire meets the opener’s control board.
• Buttons feel spongy or need a hard press. The silicone membrane under the keys wears out over time, especially on south-facing gates that sit in direct sun. We replace membranes regularly on Keller keypads that are only 4 to 5 years old.
• Gate opens on its own or won’t respond at all. A keypad that sends ghost signals can trigger the opener without anyone touching it. This is a serious security issue, not just a nuisance. If your gate moves on its own, disconnect the keypad battery and call us before using the opener again.

Replacement Cost & What’s Included

A Ghost Controls keypad replacement in Keller typically ranges from $185 to $310 installed for a basic model, while intercom repair or replacement runs $290 to $410 depending on whether we can salvage the existing wiring or need to run a new low-voltage line. The spread comes down to two things: which model you have, and whether the mounting post or brickwork needs attention before the new unit goes in. Every price we quote is settled before any work starts. You’ll know the number, we’ll agree on it, and the invoice won’t change. Our labor and the part itself are covered by the 90-Day Done Right Promise, in writing, so if anything about the repair isn’t right, we come back and make it right.

We also honor a standing $50 off any repair over $250, and a 5% senior and veteran discount. Both can apply to Ghost Controls keypad and intercom work. And if another company has given you a written estimate, we’ll give you a free second opinion on it.

DIY or Call Us?

The safe do-it-yourself checks are limited but real: swap in fresh batteries, make sure the keypad hasn’t shifted so the buttons are binding on the mounting plate, and clear away any dirt or grass clipping buildup around the wire entry point. That’s about where it ends. These are low-voltage devices, so there’s no risk of a dangerous shock, but the failure mode that strands most Keller homeowners is guessing at the wrong part. A keypad that looks dead can actually be a bad receiver board in the opener, and a new keypad won’t fix that. We’ve seen customers spend $150 on a part they didn’t need because the real problem was a chewed wire ten feet away. We handle seven other automation brands beyond Ghost Controls, including LiftMaster, Mighty Mule, and DoorKing, so we’re usually able to spot the difference on the first visit. Tell me what it is doing and what it is not doing, that is usually all I need to get started. If you’d rather have it diagnosed right the first time, call us at (254) 330-8718.

FAQs